Power network video devices with this handy PoE Injector!
- Mid or End Span Pairings
- Simple In-Line Design
- Up to 200M Runs
- 2A Load
Power over Ethernet (PoE) is a great method of supplying power to network video equipment such as IP cameras as it does away with the need for a power source local to the camera or installing extra power cable runs to the device.
In some networks the cabling infrastructure may not be PoE so the use of a PoE injector (also known as a PoE end-span or mid-span device) such as the POE200 can be a great way to overcome this.
Simply plug the non-PoE uplink cable from say a network switch into the RJ45 input and the camera into the RJ45 output then connect the power lead supplied and power up, the POE200 PoE Injector is fast to install and requires no real set up. The injector uses either the spare line/end-span pair 4/5 (+), 7/8 (-) method or the data line/mid-span pair 1/2(+), 3/6(-) method to run the power.
With the ability to produce a 100M* output with a 2A load, this offers a great solution where a PSU cannot be installed next to a PoE camera.
Compatible on 10, 100Mbp networks with maximum runs of 200 metres (100m in & 100m out) and 1000Mbps networks up to 162 metres this is a great unit to keep in your toolbox for an IP CCTV installer.
This unit measures 120x65x40mm.